CeskyFrenchGermanItalianPortugueseTurkceSpanish

What to buy for renovation in apartment
09/11/2016
In what currency to hold, to accumulate and store money?
09/11/2016

What if the float in the toilet tank water tight

What if the float in the toilet tank water tight

A toilet cistern during the day actuated very frequently. This leads to the fact that he begins to act up and break down.

Problems with the toilet tank is most often related to his leaking when it set a float no longer cope with its task.

But do not panic, because how to determine and correct the problem, due to which the float starts to leak, you can own, without the help of professionals.


Minor damage to create a lot of problems. But before you start to eliminate them, you must find the cause of the problem, and for this purpose it is useful to examine the device cistern toilet.

What is inside the toilet cistern

The designs of the tanks much, but the principle is always one andsame. This float actuating the switch water, pear, which closes drain hole and stopcock overlying water after it reaches the desired point.

The water supply to the tank in the domestic modelscarried out on the side, and imported sanitary ware - at the bottom. The difference lies only in the fact that in the first case, the filling drum is accompanied by a loud noise.

the shutter mechanism of water can be of two types: the stem and pushbutton. Spindle mechanism is now very rare, as most modern models of toilets available to the button.

The float in the toilet tank water tight: a solution

Before starting repair work should be studiedtoilet tank cover fixing device, since it can be easy to break incorrect handling, or damage the cover, because of what the cistern will have to change completely.

The float starts to leak for several reasons, among which the most common:

- Skewed poplavka-
- Hole in poplavke-
- Deterioration of the membrane.

To eliminate leakage due to misalignmentwill be sufficient to adjust the float. Arm made of brass, can simply bend, since raising and lowering it, it is easy to determine in which position it closes the water.

Problems with the control lever and plasticshould not occur. Float in a tank positioned by means of the fixing screw, allowing the lever to change the bend. If, instead of using screws, plastic rattle, then using it will need to simply fix the lever in position.

Damaged float when filling the tank with water becomes heavier and it sinks. In this case, the solution would be to replace the float or its repair.

Before starting work, close the filling valvetank and drain all water from it. After that, through the wrench, unscrew the water supply pipe and remove the old float. In its place, insert a new item and restore the water supply.

If you decide to repair the float,free it from the water and dry thoroughly. After that, with the help of heated plastic seal a hole in it and put it on him a plastic bag. But do not forget that in a short time you still have to produce its replacement, since these measures may not provide lasting results.

To replace the worn membrane, which oftenIt causes a leak of a tank of the toilet, tie the float arm to the bar, and drain all water from the tank. Then unscrew the nut that holds the discharge tube. Now disconnect the siphon and install a new membrane on the place of the old. Assembling the cistern mechanism in reverse order.

Comments are closed.