CeskyFrenchGermanItalianPortugueseTurkceSpanish

How to open files with extension tmp
09/09/2016
Occupation sales
09/09/2016

How to remove the gearbox VAZ

Removing the gearbox

Remove the gearbox is necessary to replace the clutch disk, repair or replace the clutch and to repair or replace the gearbox itself.

Since the box is quite heavy, the convenience and safety of the work must be done together, the lift or a viewing hole.

You will need

  • - A set of wrenches klyuchey-
  • - Set end golovok-
  • - Puller steering traction- hinge
  • - Assembly lopatka-
  • - screwdriver-
  • - Lifting equipment.

instructions

1

Install the vehicle on a lift or a viewing hole. Disconnect the terminals and remove the battery, remove the bottom plug in the key 17, and drain the oil from the gearbox.

2

Remove the bolts and remove the factory and more if it is installed, the engine undertray. Remove the bolt and remove the "weight" with the negative terminal of the clutch housing.

3

Release the key at the adjusting nuts 19 on the tip of the clutch cable and remove the cable end with the clutch lever on the box.

4

Disconnect from the key 13, power switching and positive wires from the traction relay of a starter. Remove the 3 screws, disconnect and remove the starter.

5

Loosen the two keys 13 on the clamp bolt and disconnect draft gear lever of the switching hinge tip located on the box.

6

Disconnect the wiring harness from the speed sensor, set top boxes, and from the inclusion of the sensor reversing light.

7

Loosen the two nuts that secure the extensions to the suspension arms, turn the key 17 for the 3 screws the front brackets and spread both extensions to the sides.

8

Remove the cotter pin and unscrew the nut wrench 22fastening of a steering rod to the lever hinge. Special puller press out the hinge pin from the stand arm. Likewise disconnect draft from the other side.

9

Remove the key 17 by two bolts on each side to release the ball joint from the steering knuckle.

10

Using a tire lever, gently squeezeany one inner CV joint and slide the drive towards. In its place, insert the old hinge or technological cover and only then disconnect the second drive.

11

With the end of the box wrench, unscrew the 3 screws 10 and remove the small plate clutch housing, flywheel cover.

12

Key or a face head on 19 loosen nuts and 3 bolts securing the clutch housing with the box to the engine.

13

Using any lifting mechanism or device, you need to hang out the engine from the lifting eyes to the engine is not turned upside down when removing the box.

14

Remove the 2 rear support nutsengine bracket to the body, then unscrew the nut and remove the bolt from the left support of the engine, then unscrew the 3 nuts of the left support to the box and remove the support.

15

Completely remove the 3 screws and remove the nutmounting box to the cylinder block and remove the gearbox. This takes her from the motor horizontally so as not to damage the spring petals on the clutch basket.

Comments are closed.