CeskyFrenchGermanItalianPortugueseTurkceSpanish

Gift ideas birthday
04/19/2016
How to make the club
04/19/2016

How to prepare the wall for painting

How to prepare the wall for painting

One of the labor-intensive processes in the repair work is to prepare the wall for painting. To cope with this task, you must have some skills of the builder.

Prepare the wall for painting difficult.

You will need

  • - spatula
  • - rollers
  • - cuvette
  • - putty
  • - primer
  • - fiberglass
  • - Bucket fillers

instructions

1

For a start you clean the walls from previouscoating. If you have wallpaper, moisten and remove them. If the walls were whitewashed, then wash it off with warm water. But if there was oil paint, then here it is, more serious. Try to clean up the former base of the wall painting, that is before the panel or the plaster. You can do it with a spatula, and if the paint does not give in, then try to do a hatchet or a chisel. In any case, carefully smooth out the surface of the walls.

2

Once you have freed the walls of the old paint proceed to repair the walls. The defects are such as: crack, fall off plaster, or even worse, the fungus on the walls.

3

If there are cracks on the wall, then penetrate themdeeper, then prime with. If the cracks are not deep, then zashpaklyuyte their basic filler, and if the crack is very deep, then repaint them with a solution. It so happens that a layer of plaster away from the wall with paint or wallpaper. Do not leave without attention to such problems. Take a hammer and knock the plaster to the base of the wall, and place chips and prime the zashtukaturte.

4

Fungus on the walls of a frequent guest on the first floor. Take special composition for the fungus and apply it with a brush, trying to rub the walls. This will help you in the future to get rid of this trouble. If the walls are still some flaws that you see, try to remove them before finishing putty.

5

The next stage of your work will be primedwalls. You saw that the walls repaired - all cracks, holes, chips are embedded. Then proceed to the entire surface of the primer walls acrylic primer, since it is applicable to all types of surfaces. Take the foam roller, dip it in the cuvette (special container for ink) with soil and press it. Now apply primer to the wall from the bottom up, and not in a hurry. Try to keep all parts of the walls have been primed.

6

To walls were subsequently withoutcracks, they glued a special fiberglass. This coating is strong enough, it is not torn, is kept firmly on the wall. Paste it with glue for vinyl wallpapers and smooth special spatula. Spread the glue as it is written on the box and let it stand for a while. Next, take the roll and glue smear the wall. Cut the fiberglass, which will be equal to the height of the wall, and stick it, smoothing out from the center to the edges. Next glue fabric overlap the previous one, and cut through both the spatula blade. You can do it, that both paintings hang butt joint. When all walls are covered with canvas, then once again go over them with glue. Do this in order not to apply the primer.

7

Now it is time to finish putty. As it is carried out fiberglass 2 times, technology is finishing. The finish coat is carried out on the? Tearing ?. Fillers Apply a thin layer on the wall of a large spatula, and the excess putty with him remove the second smaller spatula. Apply putty evenly.

8

Once the plaster dries, it proshkurtefine mesh, which can be purchased in DIY stores. Do not press down strongly on the wall to avoid scratches. And the last thing you should do is once again primed the walls. Now they are ready for painting.

Comments are closed.