Home / Hobby / Hand-made / ORIGINAL vase for flowers with a thread pattern

ORIGINAL vase for flowers with a thread pattern

/
31 Views

Original vase for flowers with a thread pattern</a>

The vase with the original design will be a wonderful decoration for the table, as well as a living room or bedroom.

A bouquet of flowers in such a vase will make the room cozy and attractive.

You will need

  • - glass vase-
  • - PVA glue-
  • - threads of cotton №10-
  • - napkin for decoupage-
  • - water-
  • - toothpick-
  • - aerosol white paint-

Instructions

1

Cover the vase with aerosol white paint as followsWay: satiated at the top (along the rim) and below - where the napkin motifs are supposed to be located. And smoothly a thin layer of paint over the entire vase, as if slightly priporoshiv. Allow the paint to dry.

2

Cut the motifs from the napkin and paste them on the vase using PVA.

3

Cut a thread 15-20 cm long and, holding one end, dip it into water so that it gets wet well. Then, in the same way, lower in the PVA glue, remove the excess glue, passing the thread along the edge of the can.

4

Lay out the curl, holding the end of the thread with the 2 fingers of the left hand, and the toothpick in the right hand, correcting, help the thread to lie beautifully.

5

After the entire length of the thread has been laid,Again go through a toothpick and align, tune the pattern. And so continue to "draw" the thread until you fill the entire area of ​​the vase. Periodically let's dry out the curls to continue on.

6

Half the beads in the beads or in this case the dots are made using putty through a medical syringe. Cover the vase with an aerosol varnish.

ORIGINAL vase for flowers with a thread pattern Was last modified: May 23rd, 2017 By Nypsiexq
It is main inner container footer text