Home / Hobby / Hand-made / How to transfer an image to a tree

How to transfer an image to a tree

/
89 Views

How to transfer an image to a tree</a>

If you are a fan of all kinds of crafts, then I think you will like this one too. I suggest you make a very unusual creation - to transfer the photo to a tree.

To be honest, I happened to learn about such creativity not very long ago, but it immediately won me over.

You will need

  • - board-
  • - the photo-
  • - laser printer-
  • - fine sandpaper-
  • - PVA glue-
  • - acrylic lacquer-
  • - sponge-
  • - Warm water-
  • - Acrylic paint.

Instructions

1

So, first you need to enlarge the photo to the required size, and then print it on a laser printer in such a way that you get a reverse image.

2

Now you need to prepare a wooden board on which the image will be transferred. It needs to be processed with sandpaper to remove all roughness and roughness.

3

Then the treated surface of the wooden board must be covered with PVA glue. If this is not, then you can use acrylic lacquer, but it is better to apply the first one.

4

Then the printed photo is necessaryPut on a wooden board so that the image was at the bottom. The printout should be carefully smoothened with a sponge and squeezed out all the air. This procedure depends on the quality of crafts, so do everything very carefully, not hurrying.

5

After the printout is applied to a wooden surface, you need to give it time to dry. It dries about 12 hours.

6

After the time has elapsed, you must remove the paper from theA board with the help of warm water and a sponge. Do not be discouraged if the paper is removed with a sponge. In this case, you can simply roll it with your finger - there will be nothing in the picture.

7

As soon as the pattern dries, it needs to be covered with acrylic lacquer, then let it dry completely. Photo transfer to tree is complete!

How to transfer an image to a tree Was last modified: May 21st, 2017 By Quowuesz
It is main inner container footer text