If you are going to build a house for a country site, or simply for a rural getaway, surely you have different issues to be overcome. And one of them: ?? How to make a roof.
Or maybe you want to replace the old and? Exhausted? a new roof? In any case, you should read this article.
We are with you now analyze how to make the roof of the metal in all its details.
First make metering ramps and install,Is strictly perpendicular to the ends of the lines of the roof eaves and skates. Next, you need to equip the crate, which can be run out of the board. The distance between the edges of crates should be equal to the size of the transverse edges of metal. That is, crates device you should start after you decide with the manufacturer of the material. Otherwise, it may happen that the transverse edges of metal will have a size of 400 mm and a crate will be built on 350 mm. The distance to the eaves from the outer edge of the cornice of the board should be 30 mm.
The edges of the sheet metal required for theirclose fastening planks, solid casing. Fixing start from the eaves edge. Experienced roofers are advised to fit flush first 3-4 leaves on the ridge, and then align and then secure them completely and strictly in turn: first, second and so on. Next, make lap fastening screws on top of the wave. Close the grooves at the edges of adjacent sheets of metal sheets. Now, every subsequent sheet when laying it with the left edge you need to lay under the previous, stowed, secured and mounted retaining material. Perform all of the following overlap in the lateral side of the sheet. the lap length should be 250 mm.
It is necessary to close the skate special elements,having the seal. These ridge elements specifically adapted for their placement on the upper ends of the sheets of roofing material, and play the role of protecting roofs from the harmful effects of the atmosphere. Finally, you need to install the cornice elements for the protection of the crates and the cornice of the flowing water.