CeskyFrenchGermanItalianPortugueseTurkceSpanish

How to cope with a child's sore throat
05/19/2016
How do you know their fines
05/19/2016

How to make repairs in the stairwell

How to make repairs in the stairwell

To repair a house entrance, collecta team of 3 or 4 people who have experience. Notify tenants that you begin to repair the door, so that they can prepare for this event.

Then the problems in the relationship between you and the tenants of the house will not be.

You will need

  • whitewash, oil paint for walls and windows, plaster, water, roller, container for the solution, airbrush

instructions

1

Generally, in our entrances repairsand it was not long ago, so whitewashing ceilings andwalls practically disappeared. Take a broom or mop and sweep up the remnants of whitewash from the walls. In inconvenient places Sweep cobwebs round brush attached to the pin with tape. After that, the ceiling and walls, moisten with water from the spray gun and let the room to dry.

2

The next stage of work - cleaning panels from the oldpainting. Take a putty knife or any other sharp instrument, and scrape off the old paint from the walls of the weak. If the plaster is removed from the wall surface, then knock it with a hammer to the ground to subsequently consolidate its new plaster.

3

All the places you've cleared the walls,prime the soil and allow the room to dry. Then proceed to the plaster of those places that you repulsed. Dissolve the dry mixture and apply to the section of the wall. If the plaster should be two times, let the first coat dry and only then apply the next layer. Do not forget to moisten the wall of the second layer with water, otherwise the plaster will not hold, and fall off.

4

While the plaster dries, the wall zashpaklyuyte. Get putty, zashpaklyuyte wall at a time and let dry. Then zashpaklyuyte them again. Typically, the walls shpaklyuyut twice, but if necessary, it is possible to make the third time.

5

When everything will be done in the stairwellpreparatory work, start whitewashing the ceiling. Close all floors at sites cardboard, and the entrance to shelter residents ask their doors. Then you can safely proceed to the whitewashed ceiling. Dissolve the oil filler in water, it is more "opaque" than a whitewash. To check the quality of the whitewash, dip your finger in the solution. If there is a thick coating of whitewash, the solution is suitable for use, if not, the solution is considered to be weak and it should be added fillers. Now the solution, strain through cheesecloth into a clean bucket and using a gun locked blanch for two times. Follow the whitewash by a helper, because it is difficult to do alone in this work.

6

After the whitewash dries, sand theplastered on the walls of the place, and whitewash, which fell on the panel, otherwise the paint will not stay at these places. Now repel panels which line will be the boundary of painting. Do it like this: take a string, roll in better blue, and set to the intended point on the panel. Pull the string and release it abruptly. On the wall will remain a trace of methylene blue. Panel height should be 150, 180 cm - this is the optimal height of the residents do not get dirty whitewash.

7

For painting porches used oil paint,to make it easier to comply with the purity of the entrance. Take the paint and pour it into a container. Paints need a lot, because in addition to painting the panels have to paint and fragments of a flight of stairs. It is desirable that it was painted in the same color, otherwise entrance will look unsightly.

8

Take the paint and pour off into the bucket. Dip fleyts in paint and move along the marked boundaries of a flat strip width of 5 cm, the same make in the floor panel. Do this around the perimeter of the entrance door, or even if it will make your partner. You are at this time, take roll, dip it in the paint and on the run-in cuvette. Now each side, to the wall near the floor and drive the roller up the panel, blending paint along the wall, then across. Try often wet roller in the paint, stain panel without gaps. After the first painting the panels, allow the surface to dry, then paint the wall a second time. Oil paint easily spreads and covers the surface well, so you will easily cope with this work.

9

Final stage repairsand in the entrance - painting of windows and railings fragments. Take the white oil paint, stir it and paint the window frames in two times. Also two times paint fragments railing.

Comments are closed.