CeskyFrenchGermanItalianPortugueseTurkceSpanish

How to make the system rollback
04/18/2016
How to water orchids at home
04/18/2016

How to make a multilevel ceiling

How to make a multilevel ceiling

Consider the stages of multi-level ceiling installation of drywall with metal frame device.

It has its own characteristics compared to standard single-level installation of the ceiling, which must be taken into account.

In this case, it offers an easy fastening option.

You will need

  • Dowel-nails, screws, drills, rotary hammers,screwdriver, a knife for cutting drywall, a special plane for zastrugivaniya end edges, 10 mm screws with a flat cap, punch, trowel, putty, paint bandages.

instructions

1

The easiest way to a multi-level ceiling can be made of drywall.
The work will consist of several stages.
Production of the uppermost portion of the ceiling.
To do this, you need to take Profile PN 27 to 30 mmfasten it to the wall on a level with the help of dowel-nails and punch. Then insert the profile of PS 60 to 30 mm and attach to the ceiling with perforated suspension of direct increments of 40 cm. To do this again need the dowel-nails and hammer.

2

Making the next level.
After this, the finished frame in raschertita lower level according to the size. Along the lines of the guides to fasten Mon. From SS racks cut parts required size and inserting them in the guide, fix vertically. Below them is worn and attached the same guide Mon. According to the drawing it is screwed to another side is the same. Regarding this third rail on the level of the wall must be screwed another guide Mon. Then, according to the desired size and cut SS rack 40 cm increments are inserted into these guide lines and via hangers attached to the upper ceiling.

3

Making drywall desired shape.
If the lower layer has a rounded shape, thensupporting rail need to be bent according to the drawing for what makes an incision 5 cm. Accordingly, the bent and lower guide. Similarly, it is going to frame any subsequent level of the drawing.

4

Sheathing plasterboard.
Then the finished frame is sheathed with plasterboard. Plasterboard attached to the guide screws 25 mm in length. If any of the end surface of the drawing to be bent, the plasterboard needs to bend accordingly. It uses a special cushion, hedgehog, through which holes are applied to the drywall. After that, but moistened with water, is maintained for some time to acquire plasticity and bent into the desired shape. The seams are glued and shpatlyuutsya.

Comments are closed.