Little ladies, as well as all adult women, like all kinds of ornaments.
So they certainly have the liking hairpin "Satin bow", which can be easily done by hand.
You will need
- - Wide, medium and narrow satin lenty-
- - Flat base for pins for hair-
- - nozhnitsy-
- - double sided tape-
- - nitki-
- - Adhesive pistolet-
- - brosh-
- - Scissors.
Cut off from a broad satin ribbon such a piece,which is 2 times the size of the future bow. Then, from the double-sided tape should be cut two narrow strips. Glue them to the edges of the tape, then it is closable in a ring. Similarly, we do another ring from a wide band.
Then take two received rings and impose on each other so that between them had at least the side of one and a half centimeters. Places bonding rings must necessarily be in the middle of a bow.
Take the thread and use it to fasten the ring of satin ribbons exactly in the middle.
Further, the course is the average width of the tape. Cut off from her strip. It needs to be bent so that it has formed a loop, the ends of which are crossed with each other at an angle of 90 degrees. The inner side of the resulting loop must be pressed against the ends of the crossing place of satin ribbon and secure it exactly in the middle by a thread.
Now we need to connect with each other and wide ribbons of tape medium and then glue them together using glue gun.
From a narrow satin ribbon cut the small strip. With it, we will close the center and decorate the bow. This ring can be attached as a glue gun, and sew the thread from the wrong side.
Decorate hairpin. To do this, from a narrow satin ribbon cut strip that is twice as long as the base clip. Glue Scotch tape.
Getting hairpin hang on the inside, and then move to the outside. Remember that on the outside need to paste over not only the hairpin, but also all of its groove and bends.
We can only paste hairpin to our hand-made article. We do this with the help of glue gun. Clip "satin bow" is ready!