CeskyFrenchGermanItalianPortugueseTurkceSpanish

What colors are best used for outdoor advertising?
08/05/2016
How to plan your life
08/05/2016

How do 3D models

Three-dimensional model of the tank from a paper

Almost everyone sooner or later think about the need to have some kind of their own interests. The options are many.

For example, many people are engaged in modeling.

This is a very good thing, because you can make not only a copy of the model, but also to invent something his own. And children will be excited about the new modelka.

So how do you make a three-dimensional model of their own hands?

You will need

  • Cardboard, paper, drawing accessories, crayons, markers, paint, PVA glue

instructions

1

First of all, decide on which model andof what you do. If you do the first time the simulation, it is not necessary to choose a complex model with lots of detail. For the first experience is ideal heavy paper or cardboard. It is also possible to use a plastic timber and in the presence of experience with these materials.

2

Make a sketch on paper of your future model. Try not to forget, but do not overload the model with unnecessary details, which would complicate its assembly. Once you have made the sketch, you can start making detailed drawings. It is desirable that the entire body of the model was made from a piece of cardboard or paper, but if this option is difficult to do, fabricate parts separately. In the process of drawing you will have a lot of extra lines. To avoid confusion, circle line, which will need to be cut, with a red pencil or felt-tip pen.

3

Now you can proceed to the excision of the workpiece onyour drawing. If you are not sure that everything is done correctly, you can first make a preform of soft paper, and try to collect it, to make sure everything is right you have calculated. The final billet crashed very carefully. Not bend in both directions on the paperboard fold lines, since its thin top layer may burst. Make a fitting piece. If all is perfect to each other, begin the assembly model. This is best suited PVA glue, as it dries leaves yellow spots, as is the case of paper glue. Gluing should be as carefully as possible, removing any excess glue.

4

Fabricate all the individual parts of your futuremodel. Together with the basic workpiece set them aside and allow the glue to grab. Once the glue is dry, assemble the model completely. Once again, set it aside to dry. Think about the appearance of your product. For decoration you can use paint, crayons, markers, stickers. It all depends on your imagination. After drying decorate modelku. You can also make a stand for it.

Comments are closed.