CeskyFrenchGermanItalianPortugueseTurkceSpanish

HOW do Cafe
08/05/2016
Get rid of pimples on your back and shoulders, finding out the cause of the
08/05/2016

How to install wing doors

How to install wing doors

As a rule, no major repair is not without replacement of interior doors. Hinged inner door may be made of various materials and very different in design.

If your doors do not belong to the category of the elite, it is possible to establish their own hands.

You will need

  • - Assembly pena-
  • - Gun mounting peny-
  • - nozhovka-
  • - knife-
  • - building level-
  • - rubanok-
  • - Thin gvozdi-
  • - The wedges, wooden
  • - Liquid to remove the mounting peny-
  • - Set door trims

instructions

1

Carefully remove the old door and prepare the doorway. Remove the new door canopies and set aside.

2

Place the door frame in the doorway andSecure it with wedges. Take the building level and place it on the threshold of the door frame so that it is positioned along the threshold. Align box on a level with the help of wooden wedges. Place the level across the threshold of the door and repeat the alignment procedure. Get a strictly horizontal position.

3

Align the hinge on the door frame strutvertically using a spirit level. To do this, you must attach to the riser level on the outside of the door opening and adjust the position of the riser with wooden beams. Carry out a similar operation on the inner side of the door frame.

4

Hang the door to the door frame, and adjust the porch. Make sure that the door is easily opened and closed.

5

Fill in the gaps between the wall and the door boxassembly foam. Working with mounting foam should be exercised carefully - do not apply once a large amount of foam. Polyurethane foam is expanding strongly in the air and, in the event of contact with a new door, remove it would be quite difficult. If you are still stained the door - use a special liquid to remove foam.

6

Wait until the foam pour. Typically, at room temperature, it takes 2-3 hours. Remove the wooden wedges and fill the hole with foam. Allow foam to dry. Trim the excess foam with a sharp knife.

7

Fix the door trim with fine "finishing" nails. Install accessories.
Your door is ready.

Comments are closed.