Home / home and family / Kitchen / How to install a dishwasher

How to install a dishwasher

/
132 Views

How to install a dishwasher</a>

If you purchased a dishwasher, do not rush to call the installer. Following simple recommendations, you can install this miracle of household appliances yourself.

Prepare the necessary tools and get down to business.

You will need

  • Multimeter
  • Screwdriver
  • Combination pliers
  • Set of wrenches

Instructions

    1

Close the water supply to the system by means of the valve. To do this, first open the water tap, and then close the water supply so that there is no excess pressure in the system.

    2

On the switchboard, disconnect the switch that serves your apartment. Make sure that the power is off.

    3

Remove the packaging from the dishwasher. Carry out an external inspection - whether there are any dents, scratches, or other damages on the unit. Download Car From side to side, thus there should be no internal knocking. If faults are found during the inspection, you have the right to request replacement of the goods.

    4

Remove the transport locks and seals. Install Car To the place intended for her. It is advisable to choose a location so that the length of the drain hose is not longer than one and a half meters, otherwise the pump will have an additional load.

    5

Align Car In all planes, it should stand smoothly and steadily. Provide for small gaps between the walls of the machine and furniture.

    6

Provide a separate water outlet forInstalling the dishwasher. On the branch pipe, install a coarse water filter, which cuts off large foreign inclusions. Install the shut-off valve in front of the filter.

    7

Connect the dishwasher Car To drain directly into the sewerage system through a siphon with an additional tap and bypass valve (it prevents the flow of water from the sink and drains into Car).

    8

From the electrical panel, conduct a separate three-wireCopper wire with a cross section of at least 2 mm. On the electrical panel, install a protective device for 16 A. The machine is connected in parallel with other machines to avoid overloading when the dishwasher is operating. The third wire (ground) is routed to the zero bus in the electrical panel.

    9

Install a 3-pole power outlet with earthing contacts. If necessary, a hole for the electric wire is punched in the wall.

    10

Perform a "cold" start of the machine (without dishes). Use the dishwashing detergent to wash away the residue of small debris and grease remaining during assembly. Check the fastness of the water inlet, the heating of the water and its drain, and also the drying mode. After this check, the dishwasher is ready for use.

How to install a dishwasher Was last modified: June 21st, 2017 By Ruigyyvv
It is main inner container footer text