MOST scary insects
How to boot from the disc the computer

How to insert the cartridge into the printer

How to insert the cartridge into the printer

Members often have to printersreplacement cartridges, because I always buy a new cartridge, the end of the old, gets in finance. It is much more profitable to simply refill the cartridge and install again.

Even a novice will be able to cope with this task.

You will need

  • A few cotton swabs, gloves, cloth and set for cartridge refilling.



In order to make the refill cartridgeprinter, do not need much time. For this procedure, you will need a few cotton swabs, gloves, cloth and set for refilling the cartridge.
First, open the cover and remove the empty cartridge from the printer. This procedure is required to carry out carefully according to the instructions that came with the printer.
The following look at the cartridge opening forrefueling, enter the syringe needle (you can feel a slight resistance, do not worry? it is a porous sponge, which is inside) and slowly, with time intervals, to have time to soak the sponge, pour the ink into the cartridge. Pour need for as long as there will be no ink in the drain hole. Then remove the syringe.


Filling and drain hole is recommended to clean the cloth.

Once you have cleared the hole, theirit is desirable to tightly seal with adhesive tape, to keep out the air inside the cartridge, and the ink does not leak. When you have finished refueling, remove the needle and syringe and rinse thoroughly.


Place the cartridge on the table? you need to defend it. It will take time, about 3-5 minutes.

Ustanovitn cartridge into the printer, but before that,Remove the masking tape with the filling and drainage holes. To install the cartridge gently take two fingers and set into place until it clicks.

You installed an ink cartridge in the printer. Now, it is desirable to turn on? Cleaning cycle ?. This cycle should be included several times until you get a good print quality.
As you can see, nothing complicated in the cartridge replacement is not. You have saved a little money, than if taken to the workshop, and speeded up the process, because the repair shop takes time.

Comments are closed.