How to install games in cell phone
As simple to cook porridge baby

HOW repaired crack

Sealing cracks - a simple process

The appearance of cracks on the walls and ceilings? this is such a problem faced by many owners of apartments.

The reasons may be different: it's flooding the apartment, and repair work, and elementary wear materials in older homes, and more.

Close up a crack in the ceiling and walls is easy.

We just need to know just what to do.



Before plugging cracksceiling, thoroughly clean the place the crack, where you will lay the solution. Then soak this place with water, so it is well soaked with it. Next comes the process of sealing the cracks.


Put the solution into the bottom recessV-shaped and smear over the entire area. Before applying the second portion of the solution, wait until the first has dried. Apply a second layer of mortar on the already solidified first so that the crack is filled by two thirds. Just smear the solution throughout the area of ​​the crack.


After hardening of the second portion of the solution proceed to the final stage of sealing the cracks. A solution of this time simultaneously apply rubbing flush with the plane of the ceiling.


Not every layman can immediately measurethe desired amount of the solution. In this case, it is recommended to act as follows: Measure the first portion of the solution, scooping up a tablespoon, to get the slide, and then prishlepnite it to the desired location. After that, trowel or spoon the same solution is carefully placed and smear it on the recess area.


To the solution was more plastic and firmer hold, add to it a little PVA glue (1:10). Only such a solution hardens very quickly, so you need to use it as quickly as possible.


You can use a PVA glue in orderprimer surface on which the plaster is applied. Dissolve this it with water and apply the brush. Immediately after that, you can apply the first layer of plaster.


Plugging cracks and plaster update should start from the bottom. Proshtukaturte first defects, which are closer to the floor, and located at the junction of wall and ceiling leave last.


The process of repairing cracks on the walls is different froma similar process on the ceiling. One has only to consider, on the walls of the solution should be applied from the bottom up, so it does not come off during application. That's all tricks.

Comments are closed.