Home / the Internet / Repair and service / How to disassemble a laptop Toshiba Satellite U840W

How to disassemble a laptop Toshiba Satellite U840W

/
187 Views

We disassemble the laptop Toshiba Satellite U840W</a>

Toshiba Satellite U840W notebook is designedSo that in order to upgrade memory or hard drive, to replace the thermal paste on the processor or clean the cooler, the laptop needs to be disassembled. Climb into the computer, not knowing where to start - a very risky operation.

Therefore, your attention is offered a step-by-step guide for dismantling the laptop Toshiba Satellite U840W-C9S.

You will need

  • - Toshiba Satellite U840W-C9S-
  • - Screwdriver Set.

Instructions

1

Turn off the computer. We spin all the screws on the underside of the laptop. Do not forget that there is a screw under the rubber cap in the center of the lid. Only 11 screws. Gently pull up the bottom cover and lift it up. It is convenient to do this with a plastic card so as not to scratch the case. Just walk around the entire perimeter map to unfasten the latches.

We remove the bottom cover of laptop Toshiba Satellite U840W

2

Carefully remove the power cable connector to release the bottom cover. Now we have everything in the palm of your hand.

Disconnect the bottom cover of the laptop U840W

3

We take out the memory module by sliding two latches on the sides of the memory module and pulling the module away from the connector.

We take out the memory from the laptop Toshiba Satellite U840W

4

To remove the cooler, the cooling processor,Unscrew the 2 screws around the cooler and 3 more screws directly above the processor. Carefully unplug the power connector by pulling it away from the connector. It has no fixatives, it opens without tricks. Everything, now you can remove the cooler. Raise it, and it is easily dismantled.

We dismantle the Toshiba Satellite U840W laptop cooler

5

A large golden loop connects different partsMotherboard, and also closes access to the hard drive and battery. To remove the loop, you need to release 2 connectors from both ends of the loop, gently pulling up the protruding edges near the connectors.

We remove a wide train

6

When the loop is removed, we will get access to the hard disk. To remove the disk from the laptop, you need to unscrew the 3 fixing screws and disconnect the SATA connector.

We remove the hard disk of Toshiba Satellite U840W laptop

7

I think you can easily figure out how to remove the Toshiba Satellite U840W laptop motherboard, how to remove the battery, etc. Collect the laptop in reverse order.

Laptop Toshiba Satellite U840W in disassembled condition

How to disassemble a laptop Toshiba Satellite U840W Was last modified: June 21st, 2017 By Wapfaabn
It is main inner container footer text