The appearance of your tiles depends not only on how beautiful she tile.
And not even just on how exactly it is laid.
Sloppy, uneven tile joints can spoil the impression of even the most expensive tiles.
Work on grouting requires expertise and professionalism.
If you have free time, patience and accuracy to cover the tile joints can be almost anyone.
You will need
- - knife-
- - Rubber shpatel-
- - gubka-
- - tryapki-
- - Metal shpatel-
- - Pliers or tongs
Carefully remove the remnants of dried glue with a metal spatula.
Remove the dividing "tic", locatedbetween the tiles, using a sharp knife. To do this, pry "cross" with the tip of a knife, and then pull out the pliers or tongs. To carry out this work should be very careful not to damage the enamel lining of the tiles.
Rinse thoroughly with water tiles. Wipe up using rags and leave for 35-45 minutes until dry.
Prepare a mixture for putty. It should be noted that the solution for grouting should be a medium consistency. Too liquid solution will require more time for drying, besides then it can quickly crack. The thick solution dries within a few minutes, and you do not have time to finish the job.
To make the putty seams tiles we recommend using small plotsrubber spatula. Select the fragment surface and apply the grout on it. Recommended fragment size - 2 sq.m. After the grout in this sector beginning to harden, wipe the tiles with a dry cloth and smooth the joints with a damp sponge. Repeat the same operation with the following section tiles. Treat the entire surface tiles and again wipe it with a dry cloth.
One day after the putty joints thoroughly wash the tiles.
Embossed porous tile is recommended to overwritenot with a spatula, and hand. Wear rubber gloves and make grout finger. Immediately after that gently wash away the remnants of grout. Working with this type of tiles It requires extreme accuracy and high speed. A slow and sloppy grout tile, you can spoil because vestsya solution firmly in its pores.