Oh Snap!

Please turn off your ad blocking mode for viewing your site content

Home / the Internet / Connectivity / How to connect satellite internet

How to connect satellite internet

/
2 Views

Now there are many different ways and possibilities for accessing the network

Now there are many different ways and opportunities for accessing the network, one such option? Connection of satellite internet.

If you decide to install a satellite Internet on your computer and do not want extra costs for the work of the master, try to establish it yourself.

You will need

  • - Cable
  • - A plate with a diameter of 90-120 cm
  • - Bracket
  • - Converter
  • - DVB-card
  • - Heat-shrink
  • - Anchor

Instructions

    1

Make sure you have all the equipment you need.

    2

Now configure the ground channel. You will need DialUp, GPRS or some other kind of connection. Ask your provider or operator how to set up the terrestrial channel.

    3

Now proceed to install the DVB-card. Install it on any available PCI slot. It is better to install it as far as possible from the TV tuner, if you have it so that it does not cause any interference.

    4

With the DVB-card in the package there should be an installation disk. Insert it and install the driver for the card from it. On your computer, the DVB card must be defined as a new network device.

    5

After you install the driver, the tray icon in the bottom right corner near the clock should show a red icon. Right-click on it and select Setup4PC.

    6

A window will open. In it, select Add and enter the name of the satellite Euteslat W6 there. Leave all other parameters as they are, without any changes. Press the OK button to confirm the selection.

    7

Now make a new transponder. For the selected Euteslat W6 satellite, select the transponder 11345, speed? 28782, polarization H (which means Horizontal). If your satellite dish is properly tuned, the signal strength band (or Signal Quality) should appear. Now we have finished setting up the transponder. Press the OK button, then the Cloze button.

    8

To configure a proxy connection, in the Setup4PC window, select the Data Servises button. A window should open. In this window, select the provider name, click Add to do this, and then type in the desired name.

    9

In the transponder window that is on the right, select the Add button, type the transponder in the window that appeared in which you selected the desired frequencies. Type the name to display in the tray, click OK.

    10

Then enter the PID List? In the window enter 1024, press the Insert button. Click OK, and then click Close.

    11

Go to the Start menu? Customization? Network connections. Go to Properties. Select the General tab, select the TCP / IP protocol in it, click the Properties button. Type the desired ip address. Max subnet? 225.225.225.0. Click OK.

    12

Download the program GlobaX, install it, run it and set up these settings:
[Server]

Port = 2001

Log = client.log

[Remote]

Name = globax

Server = (comes with the card)

Login = (comes with the card)

Passwd = (comes with the card)

Speed_in = 100,000

Speed_out = 4096

Mtu = 1500

Mru = 1500

[Local]

Remote = globax

Port = 127.0.0.1:3128

Service_int = 0

[Local]

Remote = globax

Port = 127.0.0.1:1080

Service_int = 2
Save and close the document.

    13

Connect to the Internet. Everything, on this adjustment is finished.

It is main inner container footer text