CeskyFrenchGermanItalianPortugueseTurkceSpanish

The procedure for conducting land surveying
05/10/2016
DO bedroom design with their own hands
05/10/2016

How to catch a satellite signal

How to catch a satellite signal

Satellite TV allows you to receiveDigital television signals qualities that are superior to traditional analog. In addition, it can be used anywhere in the world, but would be required satellite coverage area.

Satellite dish can not only accept, but also to transmit digital packets, thus there is a possibility to connect to the global Internet network, regardless of terrestrial transmission links.

The only thing you need to do - to catch and adjust the signal from the satellite.

You will need

  • - Satellite TV resiver-
  • - Program Satellite Antenna Alignment-
  • - TV-
  • - Compass.

instructions

1

Install a satellite dish on a wall, roofor just in the backyard on a pillar. Carefully secure it, it was impossible to wind her shift. Otherwise, the signal will be off. If the installation will produce a concrete or brick wall, it is best to use anchor bolts. Bracket for mounting the antenna must be mounted horizontally or vertically, depending on the embodiment.

2

Attach to the end of the rod plate converter(Head). Take the coaxial cable, strip it, make sure that the screen is not that it had contact with the central core. Using the f-connector, connect it to the converter. The second end secure nest satellite receiver (or dvb-card (internal or external), or television).

3

In the first case it is possible to useSatellite internet services. If the selected TV receiver, then connect it to the TV. Last enable and configure on UHF channel, just run the scanner and stop it on the TV picture with this device model.

4

Identify the geographic location coordinates, latitude and longitude of where you perform the installation of the antenna. After that, visit the website http://www.lyngsat.com/Which satellites have the opportunity to take.

5

Choose one of them, and record theTechnical data of the transponder, broadcasting a TV signal, for example, 11760v27500, where 11760 MHz frequency, v - vertical polarization, h - horizontal, 27500 - symbol rate. Furthermore, there is Ku, C-band range. Do not take at the same time signals all ranges only individually. Therefore it is necessary to correctly determine the transponder data.

6

Determine the desired location of the satellite sector. To do this, use a compass. Find the direction of the south. Then use the program Satellite Antenna Alignment. Identify in her degree direction to the south, for example, Donetsk region (Ukraine) is 37 degrees. E and 48 degrees. VS, to the south corresponds to 36 degrees. Thus, all satellites right of this line have less than 36 degrees, for example, 13e, 5e (e - east longitude, «east»).

7

Aim the antenna to the desired sector. For example, driving a setting on the satellite Hotbird 13e. Accordingly, put the compass bearing to the right of the direction of the south: 36-13 = 17 degrees. Enter the transponder settings in the satellite receiver in the tab "Settings".

8

Place the antenna in an upright position,slightly loosen, but that it was interference. Scan the sector, ie slowly move it left or right if the TV signal from the satellite is not present, then lift it slightly. Again, do the same operation until the signal is stable.

9

Attach the satellite dish in this position andconvector to adjust the signal strength again. Fix it. On the TV scan the entire range of the selected satellite transponders and save.

Comments are closed.