Using canvas allows you to crossor tapestry stitch, even very complex patterns on any fabric. However, one begins embroiderer always faced with the question, and how to be in this case with a pattern.
Do I have to translate it onto the canvas and how best to do this?
More experienced masters usually embroidered on the schemes, and the pattern is transferred only if the picture is very big and has a lot of fine details and subtle color transitions.
You will need
- - kanva-
- - Printer-
- - Waxed bumaga-
- - copy paper-
- - kalka-
- - utyug-
- - Pen or pencil.
Before starting to work, think,whether you need to carry graphic. If it is simple and without subtle color transitions, try to embroider his scheme. Divide into equal squares pattern in height and width. It is desirable that the beginning of each color coincide with the line. Transfer drawing only if you count the stitches on the pattern for some reason does not work.
Transfer the pattern on canvas There are several ways. They are not very different from those that you are transferring it to the fabric. However, the sputtering method or sewing pattern contours in this case to use meaningless. Canvas has a rather loose structure, therefore, graphite or chalk powder just vysyplyutsya through the holes, and seam curves give contours. So it is better to use carbon paper or print directly on the drawing canvas.
To convert a carbon first transferpattern on tracing paper. Cut a piece of canvas size. Put it on the copy paper to the side of the ink canvas, and on top - with a pattern tracing. The pattern should be in the position in which it is to embroidery. Cleave the entire structure with pins or staples to layers of not leaving. Circle all the lines completely or only basic drawing. Small details are not embroidered cross, can not be applied.
To print, you will need wax paper. It can be purchased in stores that sell products for offices. Cut a piece of canvas A4 size. Determine where it Wrong and the front side. Cut a sheet of waxed paper of the same size. Attach it to the canvas and align the slices. The glossy side of the paper to be in contact with the underside of the canvas. Iron it all warm iron. Stroking should be as long as the canvas is saturated with wax. Trim the edges, but do not separate layers. Lay received a "sheet" in the printer without removing it from the sheets of plain paper. The image must be imprinted on the canvas. Print the image and allow it to dry. After drying, the split canvas and paper.